Summary of common problems in hardware molds and analysis of solutions

We have developed and manufactured various types of stamping molds within 4 meters, including large-scale automobile molds and electronic product hardware molds. Our team has rich experience in hardware mold design and manufacturing. Now we will make a brief summary of the common problems encountered in hardware molds in the past, and share the solutions as follows:

1. Scrap parts  in mold holes

1) The length of the die punch is not enough-according to the punch edge, cut into the die with a thickness of 1mm more. After replacing the punch, make sure that the die does not accumulate too much waste;

2) The gap between the dies is too large-cut into the sub to reduce the gap or lengthen the punch to completely flush out the waste in the die.

3) Die punch or template is not demagnetized-demagnetize the punch or template with a demagnetizer. After completion, use a slender iron sheet about 0.5mm thick to verify that the demagnetization effect has been achieved.